chan_sccp and AX4G

Get help with installing, upgrading and running Asterisk.

Moderators: muppetmaster, Moderator, Support

chan_sccp and AX4G

Postby ourxp » Thu Sep 17, 2015 5:36 pm

Hi
I'm hoping to get some advice/guidance on a problem I am having.

I installed Elastix 2.4. I recently purchased a 4 module AX4G card and installed the drivers for Elastix (http://www.atcom.cn/dl_ax4g.html). During the install it modifies asterisk, dahdi and some other components. It successfully installs and picks up the AX4G with its modules.

I also need to install chan_sccp. In the above combination, if I install chan_sccp after this, the devices will not register. Regardless if I rebuild chan_sccp, triple check the config and tftpboot files. I know it isn't the phone because on my production setup it configures and registers fine.

Now, if I try another combination, where I install Elastix 2.4 then chan_sccp, the phone registers ok. But after I install the AX4G drivers, it throw the dialplan out of whack and while the chan_sccp phones work, it isn't picking up the context. Went as far as recompiling the pbx_config.so but still didn't work out.

Any tips here on what I could do?

I'm hoping someone has configured an AX4G card to work with chan_sccp before (but I highly doubt there could be someone?).
ourxp
Newsterisk
 
Posts: 1
Joined: Thu Sep 17, 2015 3:44 am

Return to Asterisk Support

Who is online

Users browsing this forum: No registered users and 1 guest