For IAX2 protocol port 4569 UDP
For SIP there are two types of traffic that need to be forwarded: SIP signaling and RTP media.
The default port for udp based SIP signaling is port 5060. Nevertheless, you will still need to check your PBX to find out what port it is using.
The RTP media traffic (the actual audio stream) uses a range of udp ports that varies greatly from PBX to PBX and is usually configurable. A typical range might be 10000-20000. However, you will only need to utilize a range that is large enough to support the number of simultaneous udp ports you plan to have. So in the case of port forwarding, it makes sense to configure your PBX with as small a range as makes sense - say 10000-10100 - and forward only to those portshttp://www.junctionnetworks.com/knowled ... -make-sip-