GUI 2.0 import Asterisk config

[kkuminsky]

When running v1.6 of Asterisk and installing Asterisk GUI 2.0 the Web interface is not showing any configuration from my Asterisk config.


Is there a compatibility issue with Asterisk and Asterisk GUI 2.0. It appears that the Asterisk GUI 2.0 is not supporting Asterisk 1.6 at all.



Thanks

[littlesandy]

i am trying to set up at asterisk-gui, but when I get the subversion and use the ./configure command it does nt work and gives the following error

I used this :
http://svn.digium.com/svn/asterisk-gui/branches/2.0

Error: bash: ./configure: No such file or directory

can somebody help

[ashishnayak1]

It only shows that your linux server does not have subversion installed. Depending on your type of linux you can use either of these commands to install subversion and therefore get rid of the above problem.

yum install subversion

apt-get install subversion

[david55]

This thread was dead.

The ./configure error message would not have been the result of not having svn installed, or at least not without a preceding error about command not found!

In any case AsteriskGUI is a dead product and one is outside the scope of the AsteriskNOW forum when ones starts building code from source.