Dial Plan Design with Multiple AsteriskNOW

General discussions about AsteriskNOW.

Moderators: Moderator, Support

Dial Plan Design with Multiple AsteriskNOW

Postby cprietom » Thu Aug 01, 2013 2:38 pm

Hi Everyone,

I'm desingning a Cisco Call Manager replacement with AsterisNOW. The scenario is the following:

One main site and three remote sites.

The main site with an AsteriskNOW with a PRI-E1 connected to the PSTN to handle all the inbound calls for the four sites, and with another PRI-E1 connected to a GSM channel bank to handle all the outbound calls to mobile phones from the four sites.

Another AsteriskNOW on the main site will register all the SIP phones and two 24-port analog AudioCodes gateways.

On every remote site, an AsteriskNOW with a PRI-E1 connected to the PSTN will handle all the outbound calls for every site (except for mobile phone, in that case will use the channel bank on the main site) and will handle all the SIP phones and ATAs on every site.

We need to be transparently to the users, and my concern is about for example, we have a 4031 extension on main site, a 4032 extension on site 2 and 4033 extension on site 3; and can't change that. How must i configure the outbond routes on the main site, if the extension 4032 on site 2 has to call extension 4033 on site 3, but going through the main site? or do you suggest to create outbound routes on every remote AsteriskNOW directly to all other AsteriskNOW?

Thanks in advance for your help.
Regards.
cprietom
Newsterisk
 
Posts: 2
Joined: Thu Aug 01, 2013 2:07 pm

Return to AsteriskNOW General

Who is online

Users browsing this forum: No registered users and 1 guest

cron